National Item Identification Number
00-634-9120
National Stock Number
Item Name
WASHER,FLAT
Federal Supply Class
5310
Description
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
Commercial and Government Entity Code (Supplier Data)
20284
TARGET CORPORATION
DBA TARGET
8400 LKEVIEW PKWY STE 200
PLEASANT PRAIRIE
WI
53158
262-947-8400
30003
78640
MITSUBISHI CATERPILLAR FORKLIFT
AMERICA INC
2121 W SAM HOUSTON PKWY N
HOUSTON
TX
77043
317-334-6473
83330
91967
ABBATRON LLC
DIV ABBATRON LLC
632 ARCH ST
726
MEADVILLE
PA
16335
814-724-6440
82577
66289
WISCONSIN MOTORS LLC
2020 FLETCHER CREEK DR
MEMPHIS
TN
38133
901-371-0353
Reference Numbers (Part Numbers)
10430-5
10430-5
2037AS750-03
20993
2164
2164
2164
420-73-0013
5600-4-16;
Required Categories
MATERIAL
MATERIAL DOCUMENT AND CLASSIFICATION
HOLE DIAMETER
PERIPHERAL SHAPE
Required Description
CELLULOSE OVERALL
MIL-P-20085 MIL SPEC SINGLE MATERIAL RESPONSE OVERALL
0.196