National Item Identification Number
00-297-6107
National Stock Number
Item Name
WASHER,FLAT
Federal Supply Class
5310
Description
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
Commercial and Government Entity Code (Supplier Data)
77237
77237
77237
89749
33844
KLAUER MFG CO
1185 ROOSEVELT ST
59
DUBUQUE
IA
52004
563-582-7201
05415
LINDE LIFT TRUCK CORP.
2450 WEST 5TH NORTH ST
SUMMERVILLE
SC
29483
843-875-8000
Reference Numbers (Part Numbers)
P12739
VINC2019
VINC2019
V1NC2019
V1NC2019
V2019
V2019
V2019
V2019
1038
Required Categories
MATERIAL
MATERIAL DOCUMENT AND CLASSIFICATION
HARDNESS RATING
HOLE DIAMETER;
Required Description
CORK AND
RUBBER SYNTHETIC OVERALL
MIL-G-6183 MIL SPEC SINGLE MATERIAL RESPONSE