National Item Identification Number
00-447-2678
National Stock Number
Item Name
WASHER,FLAT
Federal Supply Class
5310
Description
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
Commercial and Government Entity Code (Supplier Data)
23862
MILITARY VEHICLES OPN
GENERAL MOTORS TRUCK AND BUS GROUP
660 S BOULEVARD E
PONTIAC
MI
48341
248-456-5000
24617
7X677
19207
Reference Numbers (Part Numbers)
3659762
3659762
3659762
3659762
7411316
Required Categories
MATERIAL
MATERIAL DOCUMENT AND CLASSIFICATION
HOLE DIAMETER
PERIPHERAL SHAPE
Required Description
CORK OVERALL
MIL-G-12803 NO. P2117-B MIL SPEC SINGLE MATERIAL RESPONSE OVERALL;
