National Item Identification Number
00-134-4132
National Stock Number
Item Name
WASHER,FLAT
Federal Supply Class
5310
Referenced on: http://www.tpub.com/content/audio/TM-11-5835-247-34P/TM-11-5835-247-34P0095.htm
Referenced on: http://www.tpub.com/content/audio/TM-11-5835-247-34P/TM-11-5835-247-34P0140.htmDescription
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
Commercial and Government Entity Code (Supplier Data)
D9182
83330
91967
ABBATRON LLC
DIV ABBATRON LLC
632 ARCH ST
726
MEADVILLE
PA
16335
814-724-6440
D9182
Reference Numbers (Part Numbers)
JMD-12-040
2672
2672
2800-1066-00
Required Categories
MATERIAL
MATERIAL DOCUMENT AND CLASSIFICATION
HOLE DIAMETER
PERIPHERAL SHAPE
Required Description
PLASTIC POLYAMIDE OVERALL
MIL-M-20693 MIL SPEC SINGLE MATERIAL RESPONSE OVERALL
