National Item Identification Number
01-137-0155
National Stock Number
Item Name
WASHER,FLAT
Federal Supply Class
5310
Description
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
Commercial and Government Entity Code (Supplier Data)
03950
NAVAL INVENTORY CONTROL POINT
MECHANICSBURG
5450 CARLISLE PIKE
2020
MECHANICSBURG
PA
17055
717-605-3500
59042
BECHTEL PLANT MACHINERY INC.
DBA BECHTEL PLANT MACHINERY INC.
500 PENN CENTER BLVD
PITTSBURGH
PA
15235
412-829-8626
Reference Numbers (Part Numbers)
AN960-616MD
107J250-9
909A090-1
Required Categories
MATERIAL
SURFACE TREATMENT
SURFACE TREATMENT DOCUMENT AND CLASSIFICATION
HOLE
Required Description
STEEL OVERALL
CHROMATE OVERALL
MIL-C-23422 MIL SPEC SINGLE TREATMENT RESPONSE