National Item Identification Number
66-150-8081
National Stock Number
Item Name
WASHER,FLAT
Federal Supply Class
5310
Referenced on: http://constructionexcavators.tpub.com//TM-5-2420-230-24P/TM-5-2420-230-24P0570.htm
Referenced on: http://constructionexcavators.tpub.com//TM-5-2420-230-24P/TM-5-2420-230-24P0609.htmDescription
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.
Commercial and Government Entity Code (Supplier Data)
Z0655
AUSTRALIAN DEFENCE INDUSTRIES PTY LT
WEAPONS AND ENGINEERING DIVISION
FINN ST
PO BOX 147
BENDIGO
3550
AUSTRALIA
+61 3 5440 4311
Z6P78
WASHERS & STAMPS COMPONENTS AUSTRALI
PTY LTD
34 LASER DR
ROWVILLE
3178
AUSTRALIA
03 9763 0833
Reference Numbers (Part Numbers)
LT1238
1000272
Required Categories
Required Description